Navigon 2000S Manuel d'utilisateur télécharger pdf (Page 40)

Basic Operations

Starting the Device

24 NAVIGON 2000S | 2200T Series User’s Guide September 2008

NAVIGON, INC.

Using Standby Mode

Standby mode conserves battery time. When the device is switched back on from

Standby, the window that displayed when the device was set to Standby re-displays.

There are two ways to switch your device to Standby.

From the Main Window

On the MAIN WINDOW:

• Tap the (Standby) button.

From Any Device Window

• Press and hold the (On/Standby/Off) button for two (2) seconds, then

release.

Switching the Device Back On From Standby

To switch the Device back on:

• Press and hold the (On/Standby/Off) button for two (2) seconds, then

release.

Note: Use Standby mode only when your device will be unused for a very short time. If

left in Standby mode for an extended period, battery drain can occur as the GPS

receiver continues to draw power. For longer periods of inactivity, see “Turning the

Device Off” on page 25.

Note: To further conserve battery power, the device resets itself if left in Standby mode

for a longer time.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 123 124

Pas de commentaire

Navigon 2000S Manuel d'utilisateur Page 40